Generator stik – Toppris

Tilbud!
Generator stik - Toppris

Generator stik – Toppris

Den oprindelige pris var: 81,25 kr..Den aktuelle pris er: 42,25 kr..

Laveste pris de sidste 30 dage
PÅ LAGER FRAGT FRA 66,00 kr.
30-dages returpolitik. Er det ikke noget for dig? Returnér inden for 30 dage fra levering.
Fri fragt ved køb over 666,00 kr.
Læs mere
Brug for hjælp? Kontakt vores kundeservice.
Læs mere
Varenummer (SKU): SKU8F704DKD Kategori: Tag:


Intruktion for konvertering: /images/editor//GEU250_instructions.pdf

Alternator Terminal Conversion

Many cars with internally regulated alternators are wired for 5 electrical terminals. The ‘5 terminal’ alternator design is obsolete and is now replaced by a ‘3 terminal’ type. The following wiring instructions, provided by Lucas, outline the conversion procedure from the ‘5 terminal’ to ‘3 terminal’ type.
  • Disconnect battery.
  • Cut off wiring terminal plugs from alternator wiring.
  • Remove and discard link wire (see illustration above).
  • Remove wiring harness tape approximately 1 inch.
  • Slide small insulator over remaining IND wire (brown/yellow), and solder to the small terminal.
  • Slide large insulator over positive lead wire (brown/white), and solder to the large terminal.
  • Separately tape back onto harness, the brown and black wires not used as they are no longer required.
  • Connect the small brown/yellow IND wire to the small terminal on the alternator.
  • Connect the large brown/white positive lead to either of the two large terminals on the alternator.
  • Re-Connect the battery.
Higher output alternators may be substituted for 15 or 16ACR originals without any other alterations being necessary.

Relaterede varer